Cost

The Virginia DOT implemented and operated a variable speed limit (VSL) system for two years on a 7.5 mile section of I-495 for $3.2 million (2008).

A Northern Virginia experience


03/01/2010
Northern Virginia,Virginia,United States


Summary Information

In July 2008, a variable speed limit (VSL) system was implemented on a 7.5 mile section of I-495 (the Capital Beltway) in Virginia between the Springfield Interchange and the Woodrow Wilson Bridge. A study was conducted to evaluate performance, however, after the system was implemented changes to site conditions precluded a direct comparison of before and after data, thus a simulation model (VISSIM) was constructed to estimate system impacts.

VISSIM simulated traffic activity based on traffic volume data provided by the VDOT Traffic Monitoring System. Several measures of effectiveness (MOEs) were evaluated. Travel time, speed, queue length, number of stops, and lane change information were collected throughout the simulation. Travel time and mean speed served as operational measures, and the standard deviation of speed, mean queue length, and mean number of lane changes (per 5 minute interval) served as surrogate measures of safety. The model was calibrated using field data collected from floating car runs made between June and September 2008. Researchers identified where vehicle speeds dropped as a result of work zones and made adjustments to the model to match real-world travel times within 10 percent.

Overall, the system implemented on the Capital Beltway was designed to harmonize upstream and downstream traffic flow around each work zone. The work zones were configured with tapered lane closures that reduced travel lanes from 4 lanes to 2 lanes or from 4 lanes to 1 lane. In addition to calculating optimal speeds, the VSL system was configured to limit the frequency of speed limit changes. Previous research suggested that 2-minute intervals between posted speed limit changes would be detrimental to safety, whereas 5- or 10-minute intervals would reduce crash potential (Lee, et.al., 2004).

SYSTEM COSTS

Seven VSL signs were installed between the Springfield Interchange and the US Route 1 Interchange on the Outer Loop. Five VSL signs were installed between the Maryland-Virginia border on the WWB and the Eisenhower Connector Interchange on the Inner Loop. The total cost of the system was $3.2 million over two years including hardware, software, training, and operational support.


System Cost Comments

No comments posted to date

Comment on this System Cost

To comment on this summary, fill in the information below and click on submit. An asterisk (*) indicates a required field. Your name and email address, if provided, will not be posted, but are to contact you, if needed to clarify your comments.



Source

Work Zone Variable Speed Limit Systems: Effectiveness and System Design Issues

Author: Fudala, Nicholas J. and Michael D. Fontaine

Published By: Virginia DOT

Source Date: 03/01/2010

Other Reference Number: Report No. FHWA/VTRC 10-R20

URL: http://www.virginiadot.org/vtrc/main/online_reports/pdf/10-r20.pdf

System Cost

VSL system (hardware, software, training, and operational support included): $3.2 million.

Rating

Average User Rating

0 ( ratings)

Rate this System Cost

(click stars to rate)


Related Unit Cost Subsystems

Roadside Control (RS-C)

Keywords

smart work zone systems, VSL, smart work zone, smart work zones, Smart work zones, workzone, WZ

Cost ID: 2012-00271