Benefit

A preemptive signal control system used to minimize truck stops in Sullivan City, Texas has resulted in cost savings due to reduced fuel consumption and emissions, less pavement wear, and reduced tire and brake wear.


September 2000
Sullivan City,Texas,United States


Summary Information

This study examined the implementation of a traffic signal preemption system used to give trucks priority at a high-speed intersection (US-83 and FM-886) in Sullivan City, Texas. The Texas Department of Transportation installed a pair of magnetic loop detectors under the pavement 550 feet upstream from the intersection in order to identify trucks and determine their individual speeds. The loop detectors were connected to a Traffic Counter/Classifier (TCC) and a personal computer capable of communicating with and activating intersection signal control devices. Based on the signal phasing plan and truck speed data input, the computer placed holds on signal timing as necessary to extend green time for approaching trucks. The duration of each hold was based on truck speed. If a truck was identified during a red light, no hold call was placed. A timer relay was also used to limit hold times to 2 minutes in order to reduce the excessive wait times resulting from consecutive truck actuations.

The data was collected and analyzed to evaluate the impact of using the preemptive signal control system to minimize truck stops. The research team collected data three weeks before implementation, and then three weeks after. The "before" and "after" data were collected during typical traffic volume conditions.

FINDINGS

The signal control system benefited about four percent of the trucks on the roadway since holds were placed only when trucks needed extended green time. For a weekly volume of 2500 trucks, 100 less stops were made. The reduction in truck stops was used to determine a cost savings estimate in terms of reduced pavement wear, reduced main-street delay to trucks and other vehicles, reduced fuel consumption and emissions, and reduced tire and brake wear.

Benefit Comments

No comments posted to date

Comment on this Benefit

To comment on this summary, fill in the information below and click on submit. An asterisk (*) indicates a required field. Your name and email address, if provided, will not be posted, but are to contact you, if needed to clarify your comments.



Source

Reducing Truck Stops at High-Speed Isolated Traffic Signals

Author: Sunkari, Srinivasa R., et al.

Published By: Texas DOT

Prepared by the Texas A&M University for the Texas DOT

Source Date: September 2000

Other Reference Number: Report No. FHWA/TX-01/1439-8


Rating

Average User Rating

0 ( ratings)

Rate this Benefit

(click stars to rate)


Goal Areas

Productivity

Typical Deployment Locations

Metropolitan Areas

Keywords

coordinated signals, signal coordination, centralized signal control, signal synchronization, traffic signals, advanced signal control, signal timing optimization, coordinated signal control, advanced signal controller, traffic signal retiming, retiming

Benefit ID: 2001-00196